Experience

Power electronics, aerospace systems, and applied engineering research.

Education

University of Toronto

BASc in Electrical Engineering + PEY Co-op · Sep 2024–Expected Apr 2029

CGPA 3.54/4.00

  1. Power Management & SMPS Laboratory

    Summer Research Intern

    Resonant power conversion research for high-ratio, high-current applications.

    • Designed and prototyped a 48 V-to-1 V multiphase quasi-resonant buck converter using resonant flying-capacitor operation for soft switching at high conversion ratios.
    • Developed converter operating modes and control timing in PLECS, then characterized prototype switching behavior and efficiency.
  2. University of Toronto Aerospace Team

    Electrical Power Systems Lead

    Leading a student team developing the electrical power system for a 3U CubeSat.

    • Led development of a 6-layer EPS PCB for up to 10 W solar input, integrating buck MPPT, a 2S2P 21700 battery pack, and regulated 5 V and 3.3 V rails.
    • Implemented inter-stage voltage and current monitoring.
    • Handled component selection, Altium PCB design, assembly, and testing.
  3. In Situ and Correlative Microscopy Group

    Summer Research Intern

    FEA and CFD modeling for microscale silicon nitride devices.

    • Modeled pressure-driven deflection and failure of LPCVD silicon nitride membranes using ANSYS Mechanical.
    • Investigated thin-film residual stress and developed FEA and CFD models to evaluate microscale device design trade-offs.

Tools and skills

PCB & circuit design
Altium Designer, KiCad, LTspice, PSpice, PLECS, TINA-TI
RF & ASIC
Keysight ADS, Cadence AWR, HFSS, Maxwell, Verilog, xschem, ngspice, timing analysis
Programming
Python, MATLAB, PyVISA
Lab & fabrication
VNA, spectrum analyzer, oscilloscope, soldering and rework, machining, 3D printing, ANSYS Mechanical

Certifications: Canadian Advanced Amateur Radio Qualification · Machining Fundamentals, George Brown College (2025)